Spray Gun - Titan Control Max 1900 Pro Skid Mode D'emploi

Control Max 1900 Pro Skid
Preparation of the Coating Material
Using Control Max 1900 Pro interior wall paints, varnishes and glazes can be applied by spraying without diluting them, or by
diluting them slightly. Detailed information is available in the technical data sheet of the manufacturer ( Internet download).
1. Stir the material thoroughly and dilute it in the container as per the recommended dilution (an agitator is recommended for
stirring).
Sprayed material
Glazes
Wood preservatives containing solvents or based on water, mordants, oils, disinfection agents, plant
protective agents
Paints containing solvents and watersoluble paints, primers, vehicle coating paints, thick-ilm glazes
Interior wall paint (dispersions and latex paint)
The values in the table are reference values.
i
Find out how much the paint needs to be thinned by testing it. Details on how to test the spray paint can be found
in the section called "Spray Technique".
Assembly
1. Place both doors / laps in the storage compartment.
2. Insert the handle as shown in the picture and secure it by pushing downwards. (Fig. 2)
3. Remove the protective covers on the hose and hose connection. (Fig. 3)
4. Place the spray gun against the tapered end of the hose (Fig. 4, 1) and twist the gun onto the hose. Firmly tighten the thread
using a wrench (13).
To check whether or not the hose is pressurized, the provided pressure gauge has to be secured to the high-
pressure hose.
Danger
5. Screw the pressure gauge to the hose connection.
6. Screw the high pressure hose onto the pressure gauge.
Using a wrench (16), hold the hose connection irmly and tighten the hose with another wrench (17). (Fig. 5)
7. Slide the suction hose onto the inlet valve. Secure with the clamp. (Fig. 6)
8. Press the return hose onto the return hose itting. Secure with the clamp. (Fig. 7)
Control elements on the device (Fig. 8)
A The pressure of the spray is set by the pressure regulator.
The correct spray pressure depends on the paint being used.
The device is switched of if the pressure regulator is in position 0.
B The following settings can be made with the selector switch:
PRIME (Switch set vertically)
SPRAY (Switch set horizontally)

Spray Gun

Always lock the trigger of when attaching the spray nozzle or when the spray gun is not in use.
Danger
•
Fold the trigger lock downwards to lock the trigger (Fig. 9, A).
•
Fold the trigger lock upwards to unlock the trigger (Fig. 9, B).
Another nozzle size and gun ilter must be used, depending on the material to be processed.
i
Thin materials:
Thick materials:
Thinning recommendation
•
 For preilling the system with paint
•
For pressure relief
•
 For using the spray gun
Nozzle 311 
Nozzle 515/619 
Filter red
Filter white
GB
undiluted
undiluted
dilute by 5 - 10 %
dilute by 0-10 %
2 1