Suction Filter; Cleaning The High-Pressure Filter; Cleaning Airless Spray Gun - Titan Performance 450e Série Mode D'emploi

8.2 Suction filter
A clean suction filter always guarantees
i
maximum feed quantity, constant spraying
pressure and problem-free functioning of the
unit.
1. Screw off the filter (Fig. 5) from suction pipe.
2. Clean or replace the filter.
Carry out cleaning with a hard brush and an appropriate cleaning
agent.
8.3 Cleaning the high-pressure filter
Clean the filter cartridge regularly.
A soiled or clogged high-pressure filter can cause a poor spray
pattern or a clogged tip.
1. Turn the pressure control knob counterclockwise to
minimum pressure.
2. Open the relief valve, valve position PRIME
(k circulation).
3. Switch the unit OFF.
Unplug the power plug from the outlet.
4. Unscrew the filter housing (Fig. 6, Item 1). with a strap
wrench.
5. Pull the filter cartridge (2) from the manifold (3).
6. Clean all the parts with the corresponding cleaning agent.
If necessary, replace the filter cartridge.
7. Check the O-ring (4), replace it if necessary.
8. Push the new or cleaned filter into the pump manifold.
9. Screw in filter housing (1) and tighten it as far as possible
with the strap wrench.
4
Performance Series 450e
1
2
3
GB
8.4 Cleaning the Airless spray gun
1. Rinse Airless spray gun with an appropriate cleaning
agent.
2. Clean tip thoroughly with appropriate cleaning agent so
that no coating material residue remains.
3. Thoroughly clean the outside of the Airless spray gun.
Intake filter in Airless spray gun
1. Pull the bottom of the trigger guard forward (1) so that it
comes loose from the handle assembly (5).
2. Loosen and remove the handle assembly (5) from the gun
head (2).
3. Turning clockwise, unscrew the filter (4) from the gun body
(2).
i
Left-handed threads require turning the filter
clockwise to remove.
4. Turning counterclockwise, screw the new or cleaned filter
into the gun body.
5. Make sure all the parts are clean and the handle seal (3)
is in position inside the gun head.
6. Thread the handle assembly (5) into the gun head (2) until
secure.
7. Snap the trigger guard (1) back onto the handle assembly
(5).
1
27
Cleaning the unit (shutting down)
2
4
3
5