Starting The Engine; Preparing A New Sprayer - Titan PowrLiner 2850 Mode D'emploi

OPERATION
4.2

STARTING THE ENGINE

Follow these instructions whenever prompted in
i
this manual to start the engine.
1. Move the fuel valve lever (Fig. 10, item 2) to the open
position.
2. Move the throttle lever (3) to its middle point.
3. Move the choke lever (4) to the closed position for a cold
engine or to the open position for a warm engine,
4. Turn the engine switch (1) to the ON position, and
5. Pull the starter rope (5) briskly until the engine starts.
4
2
If choke lever (4) was moved to closed position to
i
start the engine, it must be opened again once
the engine is running.
14
4.3

PREPARING A NEW SPRAYER

i
Attention
i
1. Immerse the suction tube (Fig. 11, Item 1) and return hose
(2) into a container with mineral spirits.
2. Turn the pressure control knob counterclockwise (3) to
minimum pressure.
1
3. Turn the relief valve (4) to PRIME (k circulation).
3
5
4. Start the engine (refer to section 4.2).
5. Wait until the cleaning agent exudes from the return hose.
6. Turn the relief valve (4) to SPRAY (p spray).
7. Unlock the spray gun (refer to spray gun manual).
8. Aim the spray gun into an open waste container. Pull the
gun trigger on the right handlebar.
9. Spray the cleaning agent from the unit into an open,
grounded (earthed) collecting container.
If this unit is new, it is shipped with test fluid in
the fluid section to prevent corrosion during
shipment and storage.
thoroughly cleaned out of the system with
mineral spirits before you begin spraying.
Always keep the trigger lock on the spray gun in
the locked position while preparing the system.
Refer to the spray gun instruction manual for
trigger lock instructions.
Make sure that the spray gun does not have a tip
or tip guard installed.
PL2850
This fluid must be
2
1
3
4