Titan PowrLiner 2850 Mode D'emploi page 13

PL2850
POSITIONING THE SPRAY GUNS (BOTH UNITS)
1. Loosen the support bar knob (Fig. 7, item 1) and slide the
gun support bar (2) to the desired horizontal position. The
gun should be positioned wide enough so that the wheel
will not roll through the spray pattern.
10
4
3
6
5
2. 2nd Gun Mounting (if equipped) -
a. Slide the 2nd gun support bar assembly (3) over the end of
the 1st gun support bar (2). Secure in place by tightening
the 2nd gun support bar knob (4).
b. Loosen the 2nd gun post knob (5) and slide the post to the
desired horizontal position.
c. Run the 2nd gun cable through the block and cable guides,
underneath the frame and back towards the cart handle.
Use the tie wraps to secure the cable to the frame.
Make sure the cable is not touching the tires or
interfering with the mobility of the cart in any
way.
Attention
d. Insert the gun cable assembly (Fig. 8, item 7) into the hole
of the control guide (8) until it snaps into place.
e. Attach the hooked end of the cable into the hole of the
lever plate (9).
See the "Adjusting the Trigger Tension" section in
i
order to verify that the cable is installed properly.
1
2
7
9
8
3. Loosen the gun riser clamp(s) (Fig. 7, item 10) and slide the
spray gun(s) to the desired vertical position(s). A distance
of 6" from the tip to the spray surface is a good starting
point.
The gun support bar and the spray gun(s) can be
i
mounted on either side of the sprayer.
Refer to the "Spray Gun Positions" illustration
near the back of this manual.
The height of the spray gun affects the width
i
of the spray pattern (i.e., the lower the gun, the
smaller the line width). Tip size also affects line
width.
TRIGGER SELECTOR (TWO-GUN UNITS)
1. Set the trigger selector for proper spray gun operation.
The gun lever on the right handlebar triggers the gun or
guns. The selector on the trigger must be set for the first
gun, both guns, or the second gun.
Always switch the trigger lock on the spray
gun to the locked position before making any
adjustments to the trigger selector. Also, release
Attention
the trigger cable from its block by lifting the
cable up and out of the block. There will be a
brief triggering of the gun while releasing the
trigger cable.
A. First Gun — The first gun position is with the selector in
the left position. Push the lever toward the inside of the
frame until the pin engages the left plate.
B. Both Guns — The dual gun position is with the selector
in the center position. Push the lever toward the center
position until the pin engages both plates. The pin must
engage both plates.
C. Second Gun — The second gun position is with the
selector in the right position. Push the lever away from
the inside of the frame until the pin engages the right
plate.
A
DESCRIPTION OF UNIT
B C
13