Technical Appendix; Help In Case Of Malfunction - Lenz Digital plus LH01 Mode D'emploi

14

Technical appendix

14.1 Help in case of malfunction

Malfunction
The display of the LH01
remains dark.
The locomotive address on
the display flashes.
'AUS' is displayed.
The display is too bright.
The display is too dark.
If you contact us for help in case of malfunctions please provide a
problem description as well as the following information:

Version number of the command station

Version number of the LH01

Designation, version number and service number of all XpressNet
connected XpressNet devices (additional manual controls,
Interface etc.).
This will help us solve the problem. Thank you.
Cause
Not connected to a power
supply.
The selected address is
already being used on a
different manual control.
Another manual control has
triggered an emergency
shutdown.
The command station or
amplifier has triggered an
emergency shutdown due
to a short circuit.
The dimming value of the
display has been set to a
maximum.
The dimming value of the
display has been set to a
minimum.
Correction
Check the cabling of the
XpressNet and connected
devices.
Select a different
locomotive or turn the
rotary knob to take over the
locomotive.
Press the centre of the
rotary knob to cancel the
emergency shutdown.
Remove the short circuit. In
case of an overload divide
the layout into several
power supply sections.
Decrease the dimming
value.
Increase the dimming
value.
57