Setting And Reading The Xpressnet Address - Lenz Digital plus LH01 Mode D'emploi

44
13.1.3 Error messages when reading or writing a locomotive
address
The following error messages may be displayed while reading or
writing a locomotive address:
Action

13.2 Setting and reading the XpressNet address

For a fault-free exchange of information with the command station,
each input device connected to XpressNet (XBUS) must have its own
device address. It is, therefore, necessary to ensure that all connected
devices have different addresses. Up to 31 devices can be connected
to the XpressNet, i.e. addresses 1 to 31 can be set. Ex-factory, each
LH01 manual control is set to address 03 (the LH100 is delivered with
address 01, the LH90 with address 02). If you would like to use two or
more manual controls you will have to set a different address for each
control.
Display
A current overload (short circuit) occurred
during reading or writing. The receiver may
not be connected properly or may be faulty.
The receiver does not respond during reading
or writing, i.e. the receiver may not be
connected properly to the programming
socket
LZ100/LZV100 (the digital locomotive may
not be placed properly on the programming
track).
Press 'Esc' to return to the system menu
'L.ADR'.
Information LH01
Explanation
of the command station