Setting (Programming) Locomotive Decoders (Pom) - Lenz Digital plus LH01 Mode D'emploi

34
12 Setting (programming) locomotive decoders
(PoM)
A simple example of a decoder setting that can be changed is the so-
called starting delay. The starting delay determines whether increasing
the speed step results in an immediate increase (small value) or in a
gradual increase (high value) of the locomotive's speed.
'Programming' means changing the settings of locomotive decoders.
Settings are
('Configuration Variables'). Which settings of a locomotive decoder
can be changed is described in the corresponding operating manual.
Further detailed information on settings and CVs of Digital plus
decoders can be found in the 'Manual locomotive decoders'. You can
download this manual on the following website:
http://www.lenz-elektronik.de/download.php
The LH01 uses 'Programming in operational mode' (PoM) to set
decoder settings. The advantage of PoM is that the locomotive may be
located anywhere on the layout rather than be placed on a specific
programming track.
Action
stored as numerical
Display
values
Explanation
Select the address of the locomotive whose
CVs (settings) you would like to change
(p. 15).
Press the right side of the rotary knob until
the LED to the right shines.
Release the rotary knob to display the
locomotive address
locomotive address 1.
Information LH01
in so-called CVs
used last. Here: