Overview Of The Features Of The Lh01 - Lenz Digital plus LH01 Mode D'emploi

6
3

Overview of the features of the LH01

Locomotive
addresses
Stack for
locomotive
addresses
Locomotive
functions and
configuration
Function
acronyms
Speed steps
Club mode
Double traction
Locomotive addresses range from 1 - 9999.
Address 0 is used to control an analogue
locomotive.
The LH01 has a stack for locomotive addresses
that comprises 12 slots. The stack serves to
store the locomotive addresses as well as the
settings used most frequently.
Up to 29 functions are available for each
locomotive address.
Use of the LH01 with a command station LZV100
facilitates the independent setting of these 29
functions to permanent or temporary operation.
This setting is stored with the locomotive address
in the LZV100.
Permanent operation:
Press the key once to
enable this function and
again to disable this
function.
You can assign an acronym to each of the 29
functions from among the list of acronyms
contained in the LH01. This facilitates finding a
desired function. You can enable and disable the
display of acronyms.
The LH01 supports 28 or 128 speed steps
depending on the mode set in the command
station for the respective locomotive address.
The mode cannot be changed.
The LH01 has two so-called 'club modes' in
which certain functions of the LH01 are disabled.
This allows operation by model railway fans who
are not fully familiar with the LH01.
Two locomotives can be joined in a double
traction and controlled simultaneously.
Information LH01
Temporary operation:
This function is enabled
as long as the
corresponding key is
pressed, and disabled
as soon as the key is
released.