32
10.4 Error messages during double tractions
When assembling a double traction you may receive the following
error messages:
ERR 24:
-
-
ERR 25:
One of the two locomotives that you would like to add to the double
traction has already been called up by another manual control.
ERR 26:
One of the two locomotives that you would like to add to the double
traction is already part of another double traction.
ERR 27:
The speed step of one of the two locomotives was not set to 0 when
you assembled/deleted the double traction.
Press 'Esc' to return to 'Locomotive control'.
Press the centre of the rotary knob again to
delete the double traction.
The locomotives can now be controlled
separately.
The locomotive address was not entered into the stack before
adding the locomotive to the double traction, or
you tried to add a conventional locomotive (address 0) to a
double traction.
Information LH01