Switching Points And Signals - Lenz Digital Plus LH101 Mode D'emploi

16
Aktion
If the model clock is switched off (factor=0), the information "time
stopped" is displayed in the lower line.
While you switch a function of the locomotive on or off (i.e.
press one of the keys 0 to 9), the fast clock display
disappears briefly and the function status is displayed for
approx. 1 second.
2

Switching points and signals

Until now, the LH101 switched between two states with one key when
switching points (or signals).
Now we have integrated the possibility into the operating sequence to
set the turnout (the signal, the uncoupler) specifically in a certain
direction with two further keys. Now you have the choice:
3 PoM read
It is possible to read values in CVs via PoM under the following
conditions:
Display
Proceed from "Controlling locomotive".
With the '<=' key you change from the display
of the function status to the display of the fast
clock ...
... and back.
toggle between two states
switch specifically to " + "
switch specifically to " - "
Explanation