Settings - Schiller AT-1 Mode D'emploi

Settings

Settings Settings
Settings Settings
Each parameter is set by means of a code. This code comprises a combination of keys starting with the AL
followed by two or three numbers. The setting is confirmed with the STOP
the keyboard is dedicated to the programming function.
Note: The Alternative (ALT) function is only active for 4 seconds. If a programming key is
not pressed within 4 seconds, the unit reverts to standard mode. The ALT key must
again be pressed to activate the programming mode.
The setting is remembered and the keyboard released for other functions when the STOP
setting has been confirmed, it is stored in the memory even when the unit is switched off.
Example
If you want to set the language on your ECG unit to English, the key sequence given in the table (see page 18),
is
On the following pages the programmable parameters and the programming sequences are described in detail.
14
AL ALT - 0 - 2 - 2 - STOP AL AL AL T - 0 - 2 - 2 - STOP . . . . . T - 0 - 2 - 2 - STOP T - 0 - 2 - 2 - STOP T - 0 - 2 - 2 - STOP
STOP STOP
STOP key. As soon as the AL STOP
STOP STOP STOP key is pressed. Once a STOP
AL ALT T T T T key AL AL
AL ALT T T T T key is pressed, AL AL