Table Des Matières - Marzocchi SHIVER 35 FACTORY WORKS Mode D'emploi

IT
Sommario
1.
PREMESSE ............................................16
1.1 Orientamento della forcella .....................................16
1.2 Attrezzature .............................................................18
2.
INFORMAZIONI GENERALI ..................20
2.1 Caratteristiche .........................................................22
2.2 Componenti della forcella ........................................24
3.
NORME GENERALI
DI SICUREZZA..............................................28
3.1 Norme per la presa in morsa ...................................32
4.
MANUTENZIONE ...................................34
4.1 Inconvenienti - cause - rimedi .................................34
4.2 Tabella manutenzione periodica ..............................38
4.3 Pulizia steli ..............................................................40
4.4 Spurgo aria ..............................................................44
4.5 Scarico olio ..............................................................46
4.6 Rimozione gruppo cartuccia ....................................50
4.7 Revisione e modifi ca taratura cartuccia e
valvola della compressione ...........................................52
4.7.1 Smontaggio gruppo cartuccia ............................52
4.7.2 Revisione cartuccia ...........................................56
4.7.2.1 Smontaggio ............................................................. 56
4.7.2.2 Montaggio ............................................................... 58
4.7.3 Revisione valvola della compressione ..............60
4.7.3.1 Smontaggio ............................................................. 60
4.7.3.2 Montaggio ............................................................... 62
4.7.4 Ricomposizione gruppo cartuccia .....................64
4.8 Scomposizione stelo - portastelo e
rimozione anelli di tenuta ...............................................66
12
EN
Contents
1.
INTRODUCTION .....................................16
1.1 Orientation of the Fork .............................................16
1.2 Equipment ...............................................................18
2.
GENERAL INFORMATION.....................20
2.1 Characteristics .........................................................22
2.2 Components of the fork ...........................................24
3.
GENERAL MAINTENANCE
PROCEDURES .............................................28
3.1 Instructions for Clamping in the Vice .......................32
4.
MAINTENANCE ......................................34
4.1 Issues - Possible Causes - Solutions ......................34
4.2 Periodical Maintenance Table..................................38
4.3 Cleaning The Fork Legs ..........................................40
4.4 Bleeding the air .......................................................44
4.5 Draining the oil ........................................................46
4.6 Removing the cartridge unit ....................................50
4.7 Overhauling and modifying the cartridge unit and
compression valve setting .............................................52
4.7.1 Breaking down the cartridge ..............................52
4.7.2 Cartridge overhauling ........................................56
4.7.2.1 Dismantling ............................................................. 56
4.7.2.2 Assembly................................................................. 58
4.7.3 Compression valve overhauling ........................60
4.7.3.1 Dismantling ............................................................. 60
4.7.3.2 Assembly................................................................. 62
4.7.4 Re-assembling the cartridge unit .......................64
4.8 Breaking down the fork leg - slider and
removing the sealing rings ............................................66