CAIRE Companion 5 Manuel D'utilisation page 5

4 Power On and Warm Up
Plug the AC power cord into an AC outlet.
Toggle the Power Switch to the On position.
When the Companion 5 is powered on properly,
the green power indicator on the LED Display will
light up. All LED lights will illuminate upon start-
up. After the concentrator completes the warm-up
cycle, only the green light will remain on.
Note: After initially powering on, the O2 light will
illuminate and "O2 UP" will display on the screen until
the concentration reaches specifications.
6 Adjust Flow Setting to Prescribed Level
Use the Flow Control Knob to select the flow
prescribed by your physician.
WARNING: IT IS VERY IMPORTANT TO
SELECT ONLY THE PRESCRIBED LEVEL
Power
OF OXYGEN. DO NOT CHANGE THE
Switch
FLOW SELECTION UNLESS YOU HAVE
BEEN DIRECTED TO DO SO BY A LI-
CENSED CLINICIAN. THE OXYGEN CON-
CENTRATOR MAY BE USED DURING
SLEEP UNDER THE RECOMMENDATION
OF A QUALIFIED CLINICIAN.
Breathe normally through the nasal cannula.
To adjust flow rate:
Turn counter-clockwise to increase flow.
Turn clockwise to decrease flow.
The middle of the ball indicates flow rate. See
picture below.
Power
Indicator
LED
Companion 5
PN 21420526-C4 B | User Manual 5 - ENG