Final Setup - Siemens SITRANS FUE1010 IP40 NEMA 1 Guide Rapide

11.Slide sensor into a mounting frame back end first aligning the angled edge of the sensor
12.Tighten the sensor clamping screws to hold the sensor firmly in place.
13.Observing the upstream and downstream orientation, attach the UP and DN cables to the
3.3.3

Final Setup

1. At flowmeter, scroll down to [Install Complete]. Press the <Right Arrow> and select [Install].
2. Observe the Measured Vs window and verify a correct sound velocity measurement (if
FUE1010 IP40 (NEMA 1) Energy Portable
Compact Operating Instructions, 5/2009, A5E02384186-03
with the angled edge of the mounting frame. Keep sensor from making contact with the
pipe until it butts up against the mounting frame stop. Push sensor down to mate with pipe.
for the other sensor
sensors and make snug. Attach the other ends to the UP and DN terminals of the flowmeter
(see figure below).
①
Flow Sensor Cable Connectors
②
To Channel 2 Flow Sensor Set
Figure 3-7 Connecting Sensors to Flowmeter
Press <ENT>. Flowmeter will go through drives.
known).
3.3 Sensor Installation
③
Channel 1 - Upstream Sensor
④
Channel 1 - Downstream Sensor
Commissioning
Repeat procedure
27