Select Liquid Class
1. Press the <Down Arrow> and scroll to [Application Data].
2. Press the <Right Arrow> to select [Liquid Class].
3. Press the <Right Arrow> again and scroll to desired liquid.
4. Press <ENT> to save selection.
Select Pipe Configuration
1. Scroll down to [Pipe Config] and press the <Right Arrow>.
2. Select a configuration that approximates the conditions upstream of your transducer
3. Press <ENT> to save selection.
4. Press the <Left Arrow> and return to the main menu.
FUE1010 IP40 (NEMA 1) Energy Portable
Compact Operating Instructions, 5/2009, A5E02384186-03
①
Select from list.
mounting location. (Refer to the definitions below.)
①
Use this menu cell to enter the number of pipe diameters between the upstream configuration
and the transducer installation.
②
Use this menu cell to select the pipe configuration that most accurately represents the
upstream pipe condition.
Commissioning
3.2 Setting the Parameters
21