Télécharger Imprimer la page

Possible Breakdowns And Their Remedies; Abnormal Operation - Etesia H124DN Notice D'instructions

Masquer les pouces Voir aussi pour H124DN:

Publicité

10• POSSIBLE BREAKDOWNS AND THEIR REMEDIES
Consult the table below if you have problems with your ride-on mower. If the problem encountered is not included in
this table or if the remedy suggested does not solve the problem, contact your Dealer, who has the necessary
knowledge and equipment to deal with the problem.

ABNORMAL OPERATION

None of the indicator lights
on the dashboard come on
All the indicator lights comes on
but the starter is not working
All the indicator lights come on,
the starter is working, but the engine
does not start
The engine is running, but stalls
when the operator
starts the cutting system
The engine is running, but stalls
when the operator
starts the cutting system (H124DN, H124B,
H124DX, H124BX)
The cutting system does not engage
(with engine running)
The battery charge light stays on
after the engine has started
The audible warning device is activated
and the engine temperature indicator is on
Fill up and check if there are any leaks
The hydraulic oil temperature /
hydraulic filter clogging indicator is on,
at full engine rate but stops when idling
The hydraulic oil temperature
/ hydraulic filter clogging indicator is on
at all engine rates.
The engine oil pressure indicator is on
(after starting the engine)
The audible warning device is
activated, the cutting switch
system activated and the basket
empty (H124DN, H124B, H124DX, H124BX)
PROBABLE CAUSE
15 A fuse blown
Battery connection defective
All the conditions for safe starting
are not met
Not enough diesel
Battery insufficiently charged
The retractable parts of the cutting
system are absent or incorrectly
mounted
The retractable parts of the cutting
system are absent or
incorrectly mounted (H124DN, H124B,
H124DX, H124BX)
All the conditions for safe mowing
are not met
Battery charging circuit defective
The radiator grilles are obstructed.
Hydraulic oil cold
Hydraulic oil filter clogged (oil hot)
Temperature of hydraulic oil too high
Oil level too low
Full indicator blocked (grass deposits)
REMEDY
Replace the 15 A fuse (chapter 6.3)
Connect the battery properly (chapter 7.3)
See chapter 5.2
Fill up with diesel
Recharge the battery (chapter 7.3)
Check the charging current.
Put them back in place correctly.
(chapter 5.2)
Put them back in place correctly.
See chapter 5.2
Contact your dealer
Clean the radiator grilles (chapter 7.1.7)
Lack of coolant
Leave the engine to idle for a few minutes
and then check again
Replace the hydraulic oil filter
(chapter 6.7)
Stop the engine and contact your dealer
Fill up with oil
Remove the grass from around the
(c, photo 28, page 66)


Hide quick links:

Publicité

Chapitres

loading

Ce manuel est également adapté pour:

H124bH124dxH124bxH144mH144bmH144mx ... Afficher tout