Bosch BPT-S 3 Manuel De Service page 193

English
CAUTION
(3)
Bosch Power Tec GmbH
Risk of injury due to damaged wire strands and
incorrect screw connections
Damaged wire strands may break. Cables that are not
properly screwed into place can be pulled out or
damaged.
This may result in electric shock or heat build-up.
Do not damage wire strands when inserting them

into the spring contact
Carry out the screw connection according to

instructions
Observe the specified tightening torque

1. Strip the cable to 15 mm.
2. Insert the stripped cable up to the stop (negative
cable for DC plug (-) and positive cable for DC
socket (+) are live). Hold the housing on the screw
connection.
-
(1)
(2)
Stripped cable (1), screw connection (2), DC plug
5.13:
housing (–) (3), DC socket housing (+) (4)
3. Press down spring until it clicks audibly into place
(it must be possible to see the fine wire strands in
the chamber)
(2)
(4)
Bosch BPT-S 3 / 3.68 / 4 / 4.6 | Operating manual
Installation | 75
+
(1)