Bosch BPT-S 3 Manuel De Service page 186

68 | Installation
Bosch BPT-S 3 / 3.68 / 4 / 4.6 | Operating manual
Contact carrier (1) and lock (2)
5.8:
9. Push the seal into the housing. Make sure that the
catches are in the correct position and facing in
the right direction. If it is difficult to insert the seal:
Open out the housing collar, then insert the seal.
10.Tighten the cable screw connection with a 30 mm
torque wrench (specifications in mm) (tightening
torque 3.5 Nm)
(1)
(2)
(1)
(2)
Bosch Power Tec GmbH
English