Water Outlet; Start Of Dishwasher - FAR LVI1116 A++M Manuel D'utilisation

ENGLISH
Positioning the Appliance
Position the appliance in the desired location.
The back should rest against the wall behind
it, and the sides, along the adjacent cabinets or
walls. The dishwasher is equipped with water
supply and drain hoses that can be positioned
either to the right or the left sides to facilitate
proper installation.
How to Drain Excess Water From Hoses
If the sink is 1000 higher from the floor, the
excess water in hoses cannot be drained directly
into the sink. It will be necessary to drain
excess water from hoses into a bowl or suitable
container that is held outside and lower than the
sink.

Water Outlet

Connect the water drain hose. The drain hose
must be correctly fitted to avoid water leaks.
Ensure that the water inlet hose is not kinked or
squashed.
Extension Hose
If you need a drain hose extension, make sure to
use a similar drain hose.
It must be no longer than 4 metres; otherwise
GB-66
the cleaning effect of the dishwasher could be
reduced.
Syphon Connection
The distance between the drain connection and
the bottom of the appliance must not be longer
than 1000mm. The water drain hose should be
fixed.

Start of Dishwasher

The following things should be checked before
starting the dishwasher.
1. The dishwasher is levelled and fix ed properly
2. The inlet valve is open
3. To avoid any water leak, check if inlet valve is
correctly screwed to the dishwasher
4. The wires are tightly connected
5. The power is switched on
6. The inlet and drain hoses are knotted
7. All packing materials and printings have
been removed from the dishwasher.
ATTENTION:
After installation, please make sure to keep this
manual.
The content of this manual is very helpful to the
users.
ENGLISH
GB-67