Water Outlet - FAR LVC515DS Manuel D'utilisation

ENGLISH
Connection of drain hoses
Insert the drain hose into a drain pipe with a minimum diameter of 4cm, or let it run
into the sink, making sure to avoid bending or crimping it. The free end of the hose
must be at a height lower than 60cm and must not be immersed into water to avoid
the backflow of it.
PLEASE HANG UP THE DRAIN HOSE EITHER WAY OF A, B
NOTE
The top of the hose must be
less than 600 mm.
FRONT
Drain pipe
GB-34
Counter
A
B
40mm
How to Drain Excess Water From Hoses
If the sink is 100 0 higher from the floor, the excess water in hoses cannot be drained
directly into the sink. It will be necessary to drain excess water from hoses into a
bowl or suitable container that is held outside and lower than the sink.

Water Outlet

Connect the water drain hose. The drain hose must be correctly fitted to avoid water
leaks. Ensure that the water inlet hose is not kinked or squashed.
Extension Hose
If you need a drain hose extension, observe to use a similar drain hose.
It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher
could be reduced.
Start of dishwasher
The following things should be checked before starting the dishwasher.
The dishwasher is level and fixed properly.
1.
The inlet valve is open.
2.
Inlet hose connections are fully tightened and not leaking.
3.
The wires are tightly connected.
4.
The power is switched on.
5.
The inlet and drain hoses are not kinked.
6.
All packing and print materials should be taken out of the dishwasher.
7.
ATTENTION:
After installation, please make sure to keep this manual.
The content of this manual is very helpful to the users.
ENGLISH
GB-35