Prior Using For The First Time; Loading The Salt Into The Softener; Adjusting Salt Consumption - FAR LVC515DS Manuel D'utilisation

ENGLISH

PRIOR USING FOR THE FIRST TIME

NOTE: If your model have no water softener, you may skip this section.
A. Loading the Salt Into the Softener
Always use salt intended for use with dishwasher.
The salt container is located beneath the basket and should be filled as follows:
Attention!
• Only use salt specifically designed for use in dishwashers! All other types of salt
not specifically designed for use in a dishwasher, especially table salt, will damage
the water softener, in case of damages caused by the use of unsuitable salt the
manufacturer does not give any warranty nor is liable for any caused damages.
• Only fill with salt just before starting one of the complete washing programmes.
This will prevent any grains of salt or salty water, which may have been split,
remaining of the bottom of the machine for any period of time, which may cause
corrosion.
OPEN
A. Remove the basket and then unscrew and remove the cap from the salt container 1.
B. Before first wash, add 11t. of water in the salt container of your machine.
C. Place the end of the funnel (supplied) into the hole an d introduce about 1 kg of salt.
It is normal fora small amount of water to come out of the salt container 2.
D. After filling the container, screw the cap tightly back clockwise.
E. Usually, the salt warning light will turn off a few minutes after the salt container
has been filled.
F. Immediately after filling the salt into the salt container, a washing programme
should be started (Suggest choose rapid programme). Otherwise filter system,
pump or other important parts of the machine may be damaged by salty water.
It is out of warranty.
GB-16
NOTE:
The salt container must only be refilled when the salt warning light in the control
1.
panel comes on. Depending on how fully the salt dissolves, the salt warning light
may still be on even though the salt container is filled.
If there is no salt warning light in the control panel (For some Models),you can judge
when to load the salt into the softener by the cycles that the dishwasher had run.
If there are spills of the salt, a soak or a rapid program should be run to remove the
2.
excess salt.

Adjusting Salt Consumption

Step 1: Enter the status of salt adjustment
Close the door, within 60 seconds after power on, press Start/Pause button and hold
for 5 seconds, the machine will enter setting mode.
Step 2: select a certain level of salt consumption
Press the Start/pause button to select the proper set according to your local
environment, the sets will change in the following sequence:
H1->H2->H3->H4->H5->H6;
Step 3: Exit the status of salt adjustment
Without any operation in five seconds, the machine will exit from set mode,
the machine is into standby status.
There are 6 levels of salt consumption in all. lt is recommended to select the level
according to below table:
Water Hardness level
°dH mmol/l
1) 2)
0-5 0-0.9
6-11 1.0-2.0
12-17 2.1-3.0
18-22 3.1-4.0
23-34 4.1-6.1
35-45 6.2-8.0
ENGLISH
Setting on the Digital display
water softener stalls
1 H1
2 H2
3 H3
4* H4
5 H5
6 H6
GB-17