FAR LVC515DS Manuel D'utilisation page 36

ENGLISH
Turning On the Appliance
Starting a wash cycle...
• Draw out the basket(see the section entitled "Loading the Dishwasher" ).
• Pour in the detergent (see the section entitled "Salt, Detergent and Rinse Aid" ).
• Insert the plug into the socket. The power supply is 220-240 VAC 50 HZ,
the specification of the socket is 10 A 250 VAC.
• Make sure that the water supply is turned on to full pressure.
Press the "ON/OFF" button, then press the program button, the wash program
will be changed as follows direction ECO
Self-Cleaning lntensive Normal;
If a program is selected, the response light will light. Then press the Start/Pause
button, the dishwasher begins to start.
NOTE:
When you press the Start/Pause button to pause during washing,
the program light will stop blinking and the dishwasher will mooing
every minute unless you press the Start/Pause button to start.
Change the Programme...
Premise: You can modify the washing program, When the dishwasher just runs
fora short time. Otherwise, the detergent may have already been released, and the
appliance may have already drained the wash water. If this is the case, the detergent
dispenser must be refilled (see the section entitled "Loading the Detergent").
• Press Start/Pause Button to pause the machine when the door is closed.
Press Program Button more than three seconds the machine will be in stand by
state, then you can change the program to the desired cycle setting (see the section
entitled "Starting a wash cycle...").
NOTE: If you open the door during washing, the machine will pause. When you
close the door and press the Start/Pause Button, the machine will keep on working
after 1 0 seconds.
The program lights show the state of the dishwasher:
One of the program lights on ---------- stand by or pause
a.
One of the program lights blinking ---------- run
b.
NOTE:
If you open the door when washing, the machine will pause. When you
close the door, the machine will keep on working after 10 seconds.
If your model has broken remember function, the machine will
go on to finish the selected program after the power cut.
GB-26
Glass 90 min Rapid
Forget to Add a Dish?
A forgotten dish can be added any time before the detergent cup opens.
1. Press the Start/Pause button 4. Add forgotten dishes.
2. Open the door a little to stop the washing. 5. Close the door
3. After the spray arms stop working, you can 6. Press the Start/Pause button,the dish washer
open the door completely.
At the end of the Wash Cycle
When the working cycle has finished, the buzzer of dishwasher will sound 8 seconds,
then stop. Turn off the appliance using the ON/OFF button, shut off the water
supply and open the door of the dishwasher.
Wait a few minutes before unloading the dish washer to avoid handling the dishes
and utensils while they are still hot and more susceptible to breakage. They will also
dry better.
Switch Off the Dishwasher
Switch off the dishwasher by pressing the ON/OFF button.
1.
Turn off the water tap!
2.
Open the door carefully.
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool
down around 15 minutes before removing from the appliance.
Open the dishwasher's door, leave it ajar and wait a few minutes before removing
the dishes. In this way they will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet inside.
WARNING! It is dangerous to open the door when
washing, because the hot water may scald you
ENGLISH
will run after 10 seconds.
GB-27