Troubleshooting Tips - FAR LVC515DS Manuel D'utilisation

ENGLISH

TROUBLESHOOTING TIPS

Before Calling for Service
Review the charts on the following pages may save you from calling for service
Problem
Dishwasher doesn't Fuse blown, or the circuit breaker
start tripped.
Power supply is not turned on.
Technical
Door of dishwasher not properly
problems
closed
Water not pumped Kink in drain hose
from dishwasher
Filter clogged
Kitchen sink clogged
Suds in the tub Improper detergent
Spilled rinse-aid
Stained tub interior Detergent with colourant was
used.
General
White film on inside Hard water minerals
problems
surface
There are rust stains on The affected items are not
cutlery corrosion resistant.
A programme was not run after
dishwasher salt was added.
Traces of salt have got into the
wash cycle.
The lid of softer is loose.
GB-36
Possible Causes What To Do
Replace fuse or reset circuit breaker. Remove
any other appliances sharing the same circuit
with the dishwasher
Make sure the dishwasher is turned on and the
door is closed securely. Make sure the power
cord is properly plugged into the wall socket.
Closed dishwasher making sure that door
latches
Check drain hose
Check coarse the filter.
(see section titled "Cleaning The Filter")
Check kitchen sink to make sure it is draining
well. If problem is kitchen sink not draining,
you may need a plumber rather than a
serviceman for dishwasher.
Use only the special dishwasher detergent to
avoid suds. If this occurs, open the dishwasher
and let suds evaporate. Add 1 gallon of
cold water to the tub. Close and latch the
dishwasher, then Start the "soak" wash cycle to
drain out the water . Repeat if necessary.
Always wipe up rinse-aid spills immediately
Make sure that the detergent is the one without
colourant.
To clean the interior, use a damp sponge with
dishwasher detergent and wear rubber gloves.
Never use any other cleaner than dishwasher
detergent for the risk of foaming or suds.
Always run the Quick wash programme
without any crockery in the dishwasher
and without selecting the Turbo function (if
present), after adding dishwasher salt.
Check the lip .Ensure the fix is fine.
Knocking noise in the The spray arm is knocking against
wash cabinet an item in a basket.
Rattling noise in the Item of crockery are insecure in
Noise
wash cabinet the wash cabinet.
Knocking noise in the This may be caused by on-site
water pipes installation or the cross-section of
the piping.
The dishes are not clean The dishes were not loaded
correctly.
The programme was not powerful
enough.
Not enough detergent was
dispensed.
Item are blocking the path of
spray arms.
The filter combination in the base
Unsatisfactory
of wash cabinet is not clean or is
washing result
not correctly fitted.
This may cause the spray arm jets
to get blocked.
Cloudiness on glassware Combination of soft water and too
much detergent.
Black or gray marks Aluminum utensils have rubbed
on dishes against dishes.
Detergent left in
Dishes block detergent cups.
dispenser cups
ENGLISH
Interrupt the programme, and rearrange the
items which are obstructing the spray arm.
Interrupt the programme, and rearrange the
items of crockery.
This has no influence on dishwasher function if
in doubt, contact a suitably qualified plumber.
See notes in " Loading the Dishwasher Baskets ".
Select a more intensive programme
See" Wash Cycle Table ".
Use more detergent, or change your detergent.
Rearrange the items so that the spray can
rotate freely
Clean and/or fit the filter combination correctly.
Clean the spray arm jets. See "Cleaning the
Spray Arms"
Use less detergent if you have soft water and
select a shortest cycle to wash the glassware
and to get them clean.
Use a mild abrasive cleaner to eliminate those
marks.
Re-loading the dishes properly.
GB-37