Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
Dishwasher Features
Front view
Upper Basket
1.
Inner pipe
2.
Lower Basket
3.
Salt Container
4.
Dispenser
5.
Cup Shelf
6.
PRIOR USING FOR THE FIRST TIME
Before using your dishwasher for the first time:
A. Set the water softener
B. Add 1.5Kg dishwasher salt and then full fill the salt container with water
C. Fill the rinse aid dispenser
D. Fill in detergent
A. Water Softener
The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the water,
which would have a detrimental or adverse effect on the operation of the appliance.
The higher the content of these minerals and salts, the harder your water is.
The softener should be adjusted according to the hardness of the water in your area.
Your local Water Authority can advise you on the hardness of the water in your area.
GB-18
Back view
Spray arms
7.
Filter assembly
8.
Inlet pipe connector
9.
Drain pipe
10.
Adjuster
11.
Adjusting Salt Consumption
The dishwasher is designed to allow for adjustment in the amount of salt consumed
based on the hardness of the water used. This is intended to optimise and customise
the level of salt consumption.
Please follow the steps below for adjustment in salt consumption.
Open the door .Switch on the appliance;
1.
Press the Program button for more than 5 seconds to start the water softener set
2.
model within 60seconds after the appliance was switched on (The Salt and Rinse
aid warning lights will be on periodically when it get in the set model);
Press the Program button to select the proper set according to your local
3.
environment, the sets will change in the following sequence:
H1->H2->H3->H4->H5->H6;
Press the Power button to end the set up model.
4.
WATER HARDNESS
°dH
°fH
°Clarke
mmol/I
0~5
0~9
0~6
0~0.94
6-11
10-20
7-14
1.0-2.0
12-17
21-30
15-21
2.1-3.0
18-22
31-40
22-28
3.1-4.0
23-34
41-60
29-42
4.1-6.0
35-55
61-98
43-69
6.1-9.8
Note:1
1°dH = 1.25°Clarke = 1.78°fH = 0.178mmol/l
°DH: German degree
°fH: French degree
°Clark: British degree
Note:2
The manufactory setting: H4
Contact your local water board for information on the hardness of your water supply.
NOTE: If your model does not have any water softener,
you may skip this section.
WATER SOFTENER
The hardness of the water varies from place to place. If hard water is used in the
dishwasher, deposits will form on the dishes and utensils.
The appliance is equipped with a special softener that uses a salt container specifically
designed to eliminate lime and minerals from the water.
ENGLISH
Selector
Salt consumption
Position
(gram/cycle)
H1
0
H2
9
H3
12
H4
20
H5
30
H6
60
GB-19
Publicité
Table des Matières
