About Power Connection; Electrical Requirements; Electrical Connection; Cold Water Connection - FAR LVFI4515PI Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ENGLISH
Condensation strip
(Figure 8)
Illustration of feet adjustment
NOTE:
The maximum adjustment height of the feet is 50 mm.
Check level
Front to Back
Spirit level
Check level side to side
GB-40
Furniture
door

About Power Connection

WARNING!
For personal safety:
• Do not use an extension cord or an adapter plug with this appliance.
• Do not, under any circumstances, cut or remove the earthing.
• Connection from the power cord.

Electrical Requirements

Please look at the rating label to know the rating voltage and connect the dishwasher
to the appropriate power supply. Use the required fuse 10 amp, time delay fuse or
circuit breaker recommended and provide separate circuit serving only this appliance.
Insure proper ground
exists before use

Electrical Connection

Ensure the voltage and frequency of the power being corresponds to those on the
rating plate. Only insert the plug into an electrical socket which is earthed properly.
If the electrical socket to which the appliance must be connected is not appropriate
for the plug , replace the socket, rather than using a adaptors or the like as they could
cause overheating and burns.

Cold Water Connection

Connect the cold water supply hose to a threaded 3/4(inch)
connector and make sure that it is fastened tightly in place.
If the water pipes are new or have not been used for an
extended period of time, let the water run to make sure that
the water is clear. This precaution is needed to avoid the risk
of the water inlet to be blocked and damage the appliance.
WARNING! Please close the hydrant after using.
ENGLISH
GB-41

Publicité

Table des Matières
loading

Table des Matières