Maintenance And Cleaning; Filtering System - FAR LVFI4515PI Manuel D'utilisation

ENGLISH
Open the door, press the ON/OFF Button, and the display windows will light.
4.
Press the program Button , the wash program will be changed as follows direction:
5.
P1->P2->P3->P4->P5->P6;
If a program is selected, the LED will light. Then close the door, the dishwasher
begins to start.
Change the Program
Premise:
A cycle that is underway can only be modified if it has only been running for
1.
a short time. Otherwise, the detergent may have already been released, and the
appliance may have already drained the wash water. If this is the case, the detergent
dispenser must be refilled (see the section entitled " Loading the Detergent ").
Open the door .press the Program button more than 3 seconds , the machine will
2.
be in standby state, then you can change the program to the desired cycle setting
(see the section entitled " Starting a wash cycle. . . ").
NOTE:
If you open the door during a wash cycle, the machine will pause. The program light
will stop blinking and the buzzer will mooing every minute unless you close the door.
After you close the door, the machine will keep on working after 10 seconds.
If your model has broken remember function, the machine will go on to finish the
selected program after the power cut.
Forgot to Add a Dish?
A forgotten dish can be added any time before the detergent cup opens.
Open the door a little.
1.
After the spray arms stop working, you can open the door completely.
2.
Add forgotten dishes.
3.
Close the door.
4.
The dishwasher will run after 10 seconds.
5.
At the End of the Wash Cycle
When the working cycle has finished, the buzzer of the dishwasher will sound for
8 seconds, then stop. Turn off the appliance using the ON/OFF button, shut off the
water supply and open the door of the dishwasher.
Wait for a few minutes before unloading the dishwasher to avoid handling the dishes
and utensils while they are still hot and more susceptible to breakage. They will also
dry better.
GB-30
• Switch Off the Dishwasher
The program light is on but is not blinking, only in this case the programme has
ended.
1. Switch off the dishwasher by pressing the ON/OFF button.
2. Turn off the water tap!
• Open the door carefully.
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool
down around 15 minutes before removing from the appliance.
Open the dishwasher's door, leave it ajar and wait a few minutes before removing
the dishes. In this way they will be cooler and the drying will be improved.
• Unloading the dishwasher
It is normal that the dishwasher is wet inside.
Empty the lower basket first and then the upper one. This will avoid water
dripping from the upper Basket onto the dishes in the lower one.
WARNING!
It is dangerous to open the door when washing, because the hot water may scald you.

MAINTENANCE AND CLEANING

Filtering System

The filter prevents larger remnants of food or other objects from getting inside the pum.
The residues may block the filter, in this case they must be removed.
The filter system consists of a coarse filter, a flat
(Main filter) And a microfilter (Fine filter).
Main filter
Food and soil particles trapped in this filter are pulverized
by a special jet on the lower spray arm and washed down to
drain.
Coarse filter
Larger items, such as pieces of bones or glass, that could
block the drain are trapped in the coarse filter. To remove
the items caught by the filter, gently squeeze the tap on the
top of this filter and lift out.
Fine filter
This filter holds soil and food residues in the sump area and
prevents it from being redeposit on the dishes during wash
cycle.
ENGLISH
GB-31