Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
Tension adjustment of the door spring
The door springs are set at the factory to the proper tension for the outer door.
If aesthetic wooden panel are installed, you will have to adjust the door spring
tension. Rotate the adjusting screw to drive the adjustor to strain or relax the steel
cable (see figure 5).
Door spring tension is correct when the door remains horizontal in the fully opened
position, yet rises to a close with the slight lift of a finger.
(Figure5)
Tension adjustment of the door spring
Connection of drain hoses
Insert the drain hose into a drain pipe with a minimum diameter of 40mm, or let it
run into the sink, making sure to avoid bending or crimping it. The top of the hose
must be less than 1000mm.
PLEASE FIX THE DRAIN HOSE EITHER WAY OF A, B
Front
NOTE
The top of the
hose must
be less than
1000mm.
Drain pipe
GB-38
Counter
Dishwasher installation steps
Install the furniture door to the outer door of the dishwasher using the brackets
1.
provided. Refer to the template for positioning of the brackets.
Adjust the tension of the door springs by using an Allen key turning in a clockwise
2.
motion to tighten the left and right door springs. Failure to do this could cause
damage to your dishwasher (Illustration 2).
Connect the inlet hose to the cold water supply .
3.
Connect the drain hose. Refer to diagram. (Figure 6)
4.
Connect the power cord.
5.
Affix the condensation strip under the work surface of cabinet. Please ensure the
6.
condensation strip is flush with edge of work surface.
Place the dishwasher into position. (Illustration 4)
7.
Level the dishwasher. The rear foot can be adjusted from the front of the dishwasher
8.
by turning the Allen screw (Adjuster) in the middle of the base of dishwasher use
an Allen key (Illustration 5A). To adjust the front feet, use a flat screw driver and
turn the front feet until the dishwasher is level (Illustration 5B).
The dishwasher must be secured in place. There are two ways to do this:
9.
A. Normal work surface: Put the installation hook into the slot of the side plane and
secure it to the work surface with the wood screws (Illustration 6).
B. Marble or granite work top: Fix the side with Screw. (Illustration 7).
(Figure 7)
Dishwasher must be level for proper dish rack operation and wash performance.
Place a spirit level on door and rack track inside the tub as shown to check that the
1.
dishwasher is level.
level the dishwasher by adjusting the three levelling legs individually.
2.
When level the dishwasher, please pay attention not to let the dishwasher tip over.
3.
ENGLISH
GB-39
Publicité
Table des Matières
