Error Codes; Possible Causes - FAR LVFI4515PI Manuel D'utilisation

ENGLISH
Problem

Possible Causes

There are rust
The affected items are not
stains on cutlery corrosion resistant.
A programme was not run after
General
dishwasher salt was added.
problems
Traces of salt have gotten into the
wash cycle.
The lid of the softer is loose
Knocking noise in A spray arm is knocking against
the wash cabinet an item in a basket
Rattling noise in
Items of crockery are loose in the
Noise the wash cabinet wash cabinet
Knocking noise in This may be caused by on-site
the water pipes
installation or the cross-section of
the piping.
The dishes are not The dishes were not loaded
clean correctly.
The programme was not powerful
enough.
Not enough detergent was
dispensed.
Items are blocking the path of
spray arms.
The filter combination in the base
Unsatisfactory
of wash cabinet is not clean or
washing result
is not correctly fitted. This may
cause the spray arm jets to get
blocked.
Cloudiness on Combination of soft water and too
glassware much detergent.
Black or gray
Aluminum utensils have rubbed
marks on dishes against dishes.
Detergent left in
Dishes block detergent cups.
dispenser cups
GB-44
What To Do
Always run the quick wash programme.
without any crockery in the dishwasher
and without selecting the Turbo function
(if present), after adding dishwasher salt.
Check the lip. Ensure the fix is fine.
Interrupt the programme, and rearrange the
items which are obstructing the spray arm.
Interrupt the programme, and rearrange the
items of crockery.
This has no influence on the dishwasher
function, if in doubt, contact a suitably
qualified plumber.
See notes in "Loading the Dishwasher Baskets".
Select a more intensive programme. See "Wash
Cycle Table".
Use more detergent, or change your detergent.
Rearrange the items so that the spray can
rotate freely.
Clean and/or fit the filter combination correctly.
Clean the spray arm jets. See "Cleaning the
Spray Arms".
Use less detergent if you have soft water and
select a shortest cycle to wash the glassware
and to get them clean.
Use a mild abrasive cleaner to eliminate those
marks.
Re-loading the dishes properly.
Problem Possible Causes
The dishes are not
Improper loading
drying
Too little rinse-aid
Dishes are removed too soon
Unsatisfactory
drying result
Wrong program has been selected
Use of cutlery with a low-quality
coating

Error Codes

When some malfunctions come on, the appliance will display error codes to warn you:
Codes Meanings Possible Causes
E1 Longer inlet time. Faucets is not opened, or water intake is
restricted, or water pressure is too low.
E4 Overflow. Some element of dishwasher leaks.
WARNING!
• If overflow occurs, turn off the main water supply before calling a service.
• If there is water in the base pan because of an overfill or small leak, the water
should be removed before restarting the dishwasher.
ENGLISH
What To Do
Load the dishwasher as suggested in the
directions.
Increase the amount of rinse-aid/refill the
rinse-aid dispenser.
Do not empty your dishwasher immediately
after washing. Open the door slightly so that
the steam can escape. Begin unloading the
dishwasher only once t he dishes are barely
warm to the touch. Empty the low basket first.
This prevents water form dropping off dishes in
the upper basket.
In short program the washing temperature is
lower. This also lowers cleaning performance.
Choose a program with a long washing time.
Water drainage is more difficult with these
items. Cutlery or dishes of this type are not
suitable for washing in the dishwasher.
GB-45