Loading The Salt Into The Softener - FAR LVFI4515PI Manuel D'utilisation

ENGLISH
B. Loading the Salt Into the Softener
Always use the salt intended for use with dishwasher.
The salt container is located beneath the lower basket and should be filled as
explained in the following:
Attention!
• Only use salt specifically designed for the use in dishwashers! Every other type of
salt not specifically designed for the use in a dishwasher, especially table salt, will
damage the water softener. In case of damages caused by the use of unsuitable salt
the manufacturer does not give any warranty nor is liable for any damages caused.
• Only fill with salt just before starting one of the complete washing programs.
This will prevent any grains of salt or salty water, which may have been spilled,
remaining on the bottom of the machine for any period of time, which may cause
corrosion.
Open
A. After the lower basket has been removed, unscrew and re move the cap from the
salt container.
B. Place the end of the funnel (supplied) into the hole and introduce about 1.5kg of
dish washer salt.
C. Full fill the salt container with water. lt is normal fora small amount of water to
come out of the salt container.
D. After filling the container, screw the cap tightly back clockwise.
E. The salt warning light will stop being after the salt container has been filled with
salt.
F. Immediately after filling the salt into the salt container, a washing program should
be started (We suggest to use a short program). Otherwise the filter system, pump
or other important parts of the machine may be damaged by salty water. This is out
of warranty.
GB-20
NOTE:
The salt container must only be refilled when the salt warning light in the control
1.
panel comes on. Depending on how well the salt dissolves, the salt warning light
may still be on even though the salt container is filled.
If there is no salt warning light in the control panel (for some Models), you can
estimate when to fill the salt into the softener by the cycles that the dishwasher
has run.
If there are spills of the salt, a soak or a rapid program should be run to remove the
2.
excessive salt.
C. Fill the Rinse Aid Dispenser
Rinse Aid Dispenser
The rinse aid is released during the final rinse to prevent water from forming droplets
on your dishes, which can leave spots and streaks. It a Iso improves drying by allowing
water to roll off the dishes. Your dishwasher is designed to use liquid rinse aids. The
rinse aid dispenser is located inside the door next to the detergent dispenser. To fill
the dispenser, open the cap and pour the rinse aid into the dispenser until the level
indicator turns completely black. The volume of the rinse aid container is about 110ml.
Function of Rinse Aid
Rinse aid is automatically added during the last rinse, ensuring thorough rinsing,
and spot and streak free drying.
Attention!
Only use branded rinse aid for dishwasher. Never fill the rinse aid dispenser with
any other substances (e.g. Dishwasher cleaning agent, liquid detergent). This would
damage the appliance.
When to Refill the Rinse Aid Dispenser
If there is no rinse-aid warning light in the control panel, you can estimate the
amount from the colour of the optical level indicator "C" located next to the cap.
When the rinse-aid container is full, the whole indicator will be dark .As the
rinse-aid diminishes, the size of the dark dot decreases. You should never let the
rinse aid level fall 1 /4 full.
As the rinse aid diminishes, the size of the
black dot on the rinse aid level indicator
changes, as illustrated below.
Full
3/4 full
1/2 full
1/4 full - Should refill to eliminate spotting
Empty
ENGLISH
(Rinse-Aid indicator)
GB-21