Tension Adjustment Of The Door Spring; Connection Of Drain Hoses - FAR LVI1116 A++M Manuel D'utilisation

ENGLISH
[Figure4a]
Installation of
aesthetic panel
[Figure4b]
Ins tallation of
aesthetic wood en
panel
1. Take away the
four short screws
2. Pin up the four
long screws

Tension adjustment of the door spring

The door springs are set at the factory to the
proper tension for the outer door. If aesthetic
wooden panel are installed, you will have to
adjust the door spring tension. Rotate the
GB-58
Take away the Pin up the four
four short screws long screws
adjusting screw to drive the ad justor to strain or
relax the steel cable (see figure 5 ).
Door spring tension is correct when the door
remains horizontal in the fully opened position,
yet rises to a close with the slight lift of a finger.
[Figure5]
Tension adjustment of the
door spring

Connection of drain hoses

Insert the drain hose into a drain pipe with
a minimum diameter of 40 mm, or let it run
into the sink, making sure to avoid bending or
crimping it. The height of the drain pipe must be
less than 1000mm.
ENGLISH
GB-59