Dishwasher Installation Steps - FAR LVI1116 A++M Manuel D'utilisation

ENGLISH
Please Fix The Drain Hose Either Way Of A,B
Front
NOTE
The top of the hose
must be less than
1000mm.
Drain pipe
[Figure6]

Dishwasher installation steps

1. Install the furniture door to the outer door of
the dishwasher using the brackets provided.
Refer to the template for positioning of the
brackets.
2. Adjust the tension of the door springs by
using an Allen key turning in a clockwise
motion to tighten the left and right door
springs. Failure to do this could cause
damage to your dishwasher (Illustration 2).
3. Connect the inlet hose to the cold water
supply .
4. Connect the drain hose. Refer to diagram.
(Figure 6)
GB-60
5. Connect the power cord.
6. Affix the condensation strip under the
Counter
work surface of cabinet. Please ensure the
condensation strip is flush with edge of work
surface.
7. Place the dishwasher into position.
(Illustration 4)
8. Level the dishwasher. The rear food can be
adjusted from the front of the dishwasher
by turning the Allen screw in the middle
of the base of dishwasher use an Allen key
(Illustration 5 A). To adjust the front feet,
use a flat screw driver and turn the front feet
until the dishwasher is level (Illustration 5B).
9. The dishwasher must be secured in place.
There are two ways to do this:
A. Normal work surface: Put the installation
hook into the slot of the side plane and
secure it to the work surface with the wood
screws (Illustration 6).
B. Marble orgranite work top: Fix the side with
Screw. (Illustration 7).
ENGLISH
GB-61