Electrical Requirements; Cold Water Connection - FAR LVI1116 A++M Manuel D'utilisation

ENGLISH

Electrical Requirements

Please look at the rating label to know the
rating voltage and connect the dishwasher to
the appropriate power supply. Use the required
fuse 10 amp, time delay fuse or circuit breaker
recommended and provide separate circuit
serving only this appliance.
Electrical Connection
Ensure the voltage and
frequency of the power being
corresponds to those on the
rating plate.Only insert the
plug into an electrical socket
which is earthed properly.
If the electrical socket to
which the appliance must be
connected is not appropriate for
the plug , replace the socket,
rather than using a adaptors
or the like as they could cause
overheating and burns.
GB-64
Ensure
that proper
earthing
exists
before use

Cold Water Connection

Connect the cold water supply hose to a threaded
3/4(inch) connector and make sure that it is
fastened tightly in place.
If the water pipes are new or have not been used
for an extended period of time, let the water
run to make sure that the water is clear. This
precaution is needed to
avoid the risk of the water
inlet to be blocked and
damage the appliance.
WARNING!
Please close the hydrant after use.
ENGLISH
GB-65