FAR LVI1116 A++M Manuel D'utilisation page 58

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ENGLISH
Adjusting Rinse Aid Dispenser
Adjust
lever(Rinse)
and poor drying are a problem, increase the
amount of rinse aid dispensed by removing the
dispenser lid and rotating the dial to "5". If the
dishes still are not drying properly or show spots,
adjust the dial to the next higher lever until your
dishes a respot-free. The recommended setting
is "4". (Factory value is "4".)
NOTE:
Increase the dose if there are drops of water or
lime spots on the dishes after washing.
Reduce it if there a re sticky whitish stains on
your dishes or a bluish film on glassware or knife
blades.
GB-26
The rinse aid
dispenser has six
or four settings.
Always start with
the dispenser set
on "4". If spots
D. Function of Detergent
The chemical ingredients that compose the
detergent are necessary to remove, crush and
dispense all dirt out of the dishwasher. Most of
the commercial quality detergents are suitable for
this purpose .
WARNING!
Proper Use of Detergent.
Use only detergent specifically made for
dishwasher use. Keep your detergent fresh and
dry.
Don't put powdered detergent into the dispenser
until you are ready to wash dishes.
Detergents
There are 3 sorts of detergents
1. With phosphate and with chlorine
2. With phospha te and without chlorine
3. Without phosphate and without chlorine
Normally new pulverised detergent is without
phosphate. Thus the water softener function
of phosphate is not given. In this case we
recommend to fill salt in the salt container even
when the hardness of water is only 6 °dH. If
ENGLISH
GB-27

Hide quick links:

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Lv10c49m19wLvc518dw

Table des Matières