FAR LVI1116 A++M Manuel D'utilisation page 71

ENGLISH
water chemicals will clog the spray arm jets and
bearings.
To remove the upper spray arm, hold the nut,
rotate the arm clockwise to remove it.
To remove the lower spray arm, pull out the
spray arm upward.
Wash the arms in soapy and warm water and use
a soft brush to clean the jets. Replace them after
rinsing them thoroughly.
How to Keep Your Dishwasher in Shape
• After Every Wash
After every wash, turn off the water supply to
the appliance and leave the door slightly open
so that moisture and odours are not trapped
inside.
• Remove the Plug
Before cleaning or performing maintenance,
always remove the plug from the socket.
• No Solvents or Abrasive Cleaning
To clean the exterior and rubber parts of the
dishwasher, do not use solvents or abrasive
cleaning products.
Only use a cloth with warm soapy water.
To remove spots or stains from the surface of
GB-52
the interior, use a cloth dampened with water
an a little vinegar, or a cleaning product made
specifically for dishwashers.
• When not in use for a long time
It is recommend that you run a wash cycle
with the dishwasher empty and then remove
the plug from the socket, turn off the water
supply and leave the door of the appliance
slightly open. This will help the door seals to
last longer and prevent odours from forming
within the appliance.
• Moving the Appliance
If the appliance must be moved, try to keep it
in the vertical position. If absolutely necessary,
it can be positioned on its back.
• Seals
One of the factors that cause odours to form
in the dishwasher is remaining food strapped
in the seals. Periodic cleaning with a damp
sponge will prevent this from occurring.
ENGLISH
GB-53