Changing The Program Mid-Cycle - FAR LVI1116 A++M Manuel D'utilisation

ENGLISH
Turning On the Applince
Starting a cycle wash
1. Draw out the lower and upper basket,
load the dishes and push them back. It is
recommended to load the lower basket first,
then the upper one (see the section entitled
"Loading the Dishwasher").
2. Pour in the detergent (see the section entitled
Salt, Detergent and Rinse Aid).
3. Insert the plug into the socket. The power
supply is 220-240 VAC /50 HZ, the
specification of the socket is 10A 250VAC.
Make sure that the water supply is turned on
to full pressure.
4. Open the door, press the power button, and
the On/Off light will turn on.
5. Press the program Button, the wash program
will be changed as follows direction:
Intensive -> Normal -> Eco -> Glass ->
90Min -> Rapid;
If a program is selected, the response
light will turn on. Then close the door, the
dishwasher will start its cycle.
GB-42

Changing the Program Mid-Cycle

Premise:
1. A running cycle can only be changed if
it has only been running for a short time.
Otherwise, the detergent may have already
been released, and the appliance may have
already drained the wash water. If this is
the case, the detergent dispenser must be
refilled (see the section entitled "Loading the
Detergent").
2. Open the door, press the Start/Pause button
to stop the machine. Press the Program
button more than 3 seconds, the machine will
be in standby state, then you can change the
program to the desired cycle setting (see the
section entitled "Starting a wash cycle...").
NOTE:
If you open the door during a wash cycle, the
machine will pause. The program light will
stop blinking and the buzzer will mooing every
minute unless you close the door. After you close
the door, the machine will keep on working
again.
ENGLISH
GB-43