Water Outlet; Start Of Dishwasher - FAR LV12C47MI18W Manuel D'utilisation

ENGLISH
How to Drain Excess Water from Hoses
If the sink is 1000 higher from the floor, the
excess water in hoses cannot be drained directly
into the sink. It will be necessary to drain
excess water from hoses into a bowl or suitable
container that is held outside and lower than the
sink.

Water Outlet

Connect the water drain hose. The drain hose
must be correctly fitted to avoid water leaks.
Ensure that the water drain hose is not kinked or
squashed.
Extension Hose
If you need a drain hose extension, make sure to
use a similar drain hose.
It must be no longer than 4 metres; otherwise
the cleaning effect of the dishwasher could be
reduced.
Syphon Connection
The waste connection must be at a height less
than 1000 mm (maximum) from the bottom of
the dish.
The water drain hose should be fixed.
GB-48

Start of Dishwasher

The following things should be checked before
starting the dishwasher.
The dishwasher is level and fixed properly
1. The inlet valve is open
2. Fill hose connections are fully tightened and
not leaking
3. The wires are tightly connected
4. The power is switched on
5. The inlet and drain hoses are knotted
6. All packing materials and printings should
be taken out from the dishwasher
Attention: After installation, please make sure
to keep this manual.
The content of this manual is very helpful to the
users.
ENGLISH
GB-49