Protect Against Freezing; Cleaning The Spray Arms - FAR LV12C47MI18W Manuel D'utilisation

ENGLISH

Protect Against Freezing

Please take frost protection measures on the
dishwasher in winter. Every time after washing
cycles, please operate as follows:
1. Cut off the electrical power to the
dishwasher.
2. Turn off the water supply and disconnect the
water inlet pipe from the water valve.
3. Drain the water from the inlet pipe and
water valve. (Use a pan to gather the water)
4. Reconnect the water inlet pipe to the water
valve.
5. Remove the filter at the bottom of the tub
and use a sponge to soak up water in the
sump.
NOTE: If your dishwasher cannot work because
of the ice, please contact professional service
persons.

Cleaning the Spray Arms

It is necessary to clean the spray
arms regularly for hard water
chemicals will clog the spray arm
jets and bearings.
GB-42
Open
To remove the lower spray arm, pull out the
spray arm upward.
To remove the upper spray arm, hold the nut,
rotate the arm clockwise to remove it.
Wash the arms in soapy and warm water and use
a soft brush to clean the jets. Replace them after
rinsing them thoroughly.
How to Keep Your Dishwasher in Shape
After Every Wash
After every wash, turn off the water supply to
the appliance and leave the door slightly open so
that moisture and odours are not trapped inside.
Remove the Plug
Before cleaning or performing maintenance,
always remove the plug from the socket.
No Solvents or Abrasive Cleaning
To clean the exterior and rubber parts of the
dishwasher, do not use solvents or abrasive
cleaning products.
Only use a cloth with warm soapy water.
To remove spots or stains from the surface of the
interior, use a cloth dampened with water a little
ENGLISH
GB-43