Protect Against Freezing; Cleaning The Spray Arms - FAR LV12C47MI17W Manuel D'utilisation

ENGLISH
WARNING!
• Never use a spray cleaner to clean the door
panel as it may damage the door lock and
electrical components.
• Abrasive agents or some paper towels should
not be used because of the risk of scratching
or leaving spots on the stainless steel surface.

Protect Against Freezing

please take frost protection measures on the
dishwasher in winter. Every time after washing
cycles, please operate as follows:
1. Cut off the electrical power to the
dishwasher.
2. Turn off the water supply and disconnect the
water inlet pipe from the water valve.
3. Drain the water from the inlet pipe and
water valve. (Use a pan to gather the water)
4. Reconnect the water inlet pipe to the water
valve.
5. Remove the filter at the bottom of the tub
and use a sponge to soak up water in the
sump.
GB-44
NOTE: If your dishwasher cannot work
because of the ice, please contact professional
service persons.

Cleaning the Spray Arms

It is necessary to clean the spray
arms regularly for hard water
chemicals will clog the spray
arm jets and bearings.
To remove the upper spray arm,
hold the nut, rotate the arm
clockwise to remove it.
To remove the lower spray arm,
pull out the spray arm upward.
Wash the arms in soapy and
warm water and use a soft brush
to clean the jets. Replace them
after rinsing them thoroughly.
How to Keep Your Dishwasher in Shape
• After Every Wash
After every wash, turn off the water supply to
the appliance and leave the door slightly open so
that moisture and odours are not trapped inside.
• Remove the Plug
Before cleaning or performing maintenance,
ENGLISH
GB-45