Cold Water Connection; Drain Hose Connection - FAR LV12C47MI17W Manuel D'utilisation

ENGLISH
Water Connection

Cold Water Connection

Connect the cold water supply
hose to a threaded 3/4(inch)
connector and make sure that
it is fastened tightly in place.
If the water pipes are new
or have not been used for an
extended period of time, let
the water run to make sure
that the water is clear. This
precaution is needed to avoid
the risk of the water inlet to
be blocked and damage the
appliance.
WARNING!
Please close the hydrant after using.
GB-50

Drain hose Connection

Insert the drain hose into a drain pipe with
a minimum diameter of 40mm, or let it run
into the sink, making sure to avoid bending or
crimping it. The top of the hose must be less
than 1000mm.
PLEASE HANG UP THE DRAIN HOSE
EITHER WAY OF A, B
Front
NOTE: The
top of the
hose must
be less than
1000mm.
Drain pipe
How to Drain Excess Water From Hoses
If the sink is 1000 higher from the floor, the
excess water in hoses cannot be drained directly
into the sink. It will be necessary to drain
excess water from hoses into a bowl or suitable
container that is held outside and lower than the
sink.
ENGLISH
Counter
GB-51