FAR LV12C47MI17W Manuel D'utilisation page 59

ENGLISH
It is commended to load the lower basket
first, then the upper one (see the section
entitled "Loading the Dishwasher").
2. Pour in the detergent (see the section entitled
"Salt, Detergent and Rinse Aid").
3. Insert the plug into the socket. The power
supply is 220-240 VAC /50 HZ, the
specification of the socket is 10A 250VAC.
Make sure that the water supply is turned on
to full pressure.
4. Close the door, press the Power button, to
switch on the machine.
5. Press the program button, the wash program
will be changed as follows direction:
ECO->90mins->Rapid->Intensive;
If a program is selected, the response light
will light. Then press the Start/Pause button,
the dishwasher begins to start.
Change the Program...
Premise:
1. A cycle that is underway can only be
modified if it has only been running for a
short time. Otherwise, the detergent may
have already been released, and the appliance
may have already drained the wash water.
GB-36
If this is the case, the detergent dispenser
must be refilled (see the section entitled
"Loading the Detergent" ).
2. Press the Start/Pause button, the machine
will be in standby state, press the program
button more than 3s then you can change the
program to the desired cycle setting (see the
section entitled "Starting a wash cycle. . .»).
NOTE:
If you open the door during a wash cycle, the
machine will pause. The program light will
stop blinking and the buzzer will mooing every
minute unless you close the door. After you close
the door, the machine will keep on working after
10 seconds.
If your model has broken remember function,
the machine will go on to finish the selected
program after the power cut.
Forgot to Add a Dish?
A forgotten dish can be added any time before
the detergent cup opens.
1. Press the Start/Pause Button to stop the
washing.
2. Open the door a little.
3. After the spray arms stop working, you can
ENGLISH
GB-37