Before Initial Use - Beem 02049 Mode D'emploi

27
• Never pull or carry the device by the mains cable. When you pull it out of the plug socket,
always pull on the mains plug and never the mains cable!
• Protect the device from other heat sources, naked fl ames, sub-zero temperatures, persis-
tent moisture, wet conditions and impacts.
• Use only original spare parts from the manufacturer.

Before Initial Use

NOTES
• Always set up the device with a clear space at the sides (at least 20 cm) and clear space
above it (at least 30 cm) on a fl at, solid and heat-resistant surface that is resistant to
splashing.
• Do not place the device below kitchen wall units or similar cupboards. The rising steam
could cause damage to them!
• The surfaces of furniture may possibly contain elements which can attack and soften the
adjustable feet of the device. If necessary, place a suitable pad below the adjustable feet.
• There may still be some production residues on the device. To avoid harmful effects
to your health, clean the device before you fi rst use it (see the "Cleaning and Care"
chapter).
• Keep the original packaging during the warranty period of the device so that the
device can be properly packaged up if it needs to be returned. The warranty claim
shall lapse if any damage is caused during transport.
1. Remove all packaging materials and any possible protective fi lms used for protection during
transportation. Never remove the rating plate and any possible warnings!
2. Wipe down the device with a clean, damp cloth. Rinse the thermal jug (6), the fi lter insert
(16) and the permanent fi lter (17) as well as the measuring spoon (10) with a little mild
detergent and clear water.
3. Set up the device in a suitable location, following the safety instructions and the notes pro-
vided at the beginning of this chapter.
4. Pull the mains cable out of the cable compartment and plug it into a properly installed,
easily accessible plug socket.
5. Before you enjoy your fi rst coffee, we recommend that you carry out a trial run with coffee
beans to remove any possible production residues in the water system and in the grinder
shaft (14). To do this, follow the instructions in the "Handling and Operation" and "Use"
chapters.
When the device is fi rst used, production-related additives (e.g. grease) may cause a small
amount of smoke and / or an odour to be produced. This is normal and not a device
defect.
02049_DE-EN-FR-ES-IT_A5_V4.indb 27 02049_DE-EN-FR-ES-IT_A5_V4.indb 27
EN
24.09.2018 15:51:07 24.09.2018 15:51:07