Before Initial Use - Beem Thermo2Go Mode D'emploi

23

Before Initial Use

NOTES
• Always set up the device with a clear space at the sides (at least 20 cm) and clear
space above it (at least 30 cm) on a fl at, solid and heat-resistant surface that is
resistant to splashing.
• Do not place the device below kitchen wall units or similar cupboards. The rising
steam could cause damage to them!
• The surfaces of furniture may possibly contain elements which can attack and
soften the adjustable feet of the device. If necessary, place a suitable pad below
the adjustable feet.
• There may still be some production residues on the device. To avoid harmful
effects to your health, clean the device before you fi rst use it (see the "Cleaning
and Care" chapter).
1. Wipe down the device with a clean, damp cloth. Clean the permanent fi lter (16), the
fi lter insert (17) and the to-go coffee cup (14) with mild detergent and warm water or in
the dishwasher.
2. Set up the device in a suitable location, following the safety instructions and the notes
provided at the beginning of this chapter.
3. Completely unwind the mains cable and plug into a properly installed plug socket that
is easily accessible.
4. Before you enjoy your fi rst coffee, we recommend that you carry out a trial run to
remove any possible production residues in the water system. To do this, follow the
instructions in the "Preparation" chapter.
When the device is fi rst used, production-related additives (e.g. grease) may cause a
small amount of smoke and / or an odour to be produced. This is normal and not a
device defect.
5. Perform this process twice. Do not drink this coff ee!
6. Clean the device and accessories (see the "Cleaning and Care" chapter).
03510_DE-EN-FR-NL_A5_V1.indb 23 03510_DE-EN-FR-NL_A5_V1.indb 23
EN
19.10.2017 09:52:23 19.10.2017 09:52:23