Before Initial Operation - Beem M300-F Mode D'emploi

28. Never place the utensil near a gas flame, electric hotplate or other source of heat.
External heat can damage the utensil.
29. Never cover the appliance because this will prevent the heat escaping.
30. Switch the unit on only if the water tank is full.
31. Never use warm or hot water to reduce the brewing time.
32. Furniture today is coated with many types of paints and plastics and is treated with
many different kinds of care products. It can therefore not be entirely excluded that
some of these materials contain components which corrode and soften the rubber
feet. If necessary, place a mat under the feet of the appliance.
WARNING: No liability can be assumed for any damage in the case of misuse or
incorrect operation.
5

Before initial operation

Make sure that all packaging material has been removed from the appliance
(protective film etc.).
Check that all parts are there (see chapter 3 "Description of appliance and scope of
delivery").
Leave the specification plate and any warning notices on the appliance.
Place the unit on a heat-resistant waterproof and flat surface.
Do not place the unit directly next to water taps or sinks.
CAUTION: Make sure that the appliance is not damaged. If parts are damaged,
do not operate the appliance. Instead, contact qualified service personnel.
1. Wipe the appliance with a damp cloth and then dry it with a kitchen towel.
2. Clean the unit and accessories thoroughly before using for the first time, as described
in chapter 7.
3. Insert the mains plug in a power socket.
4. Carry out 2-3 brewing processes, as described in chapter 6 in order to remove any
particles left over from production and assembly. Pour the coffee away!
Your Lattespresso Espresso maker is now ready for operation.
NOTE: When you use the appliance for the first time, there might be some slight
fumes.
NOTE: The appliance has a touch key (see photo) that can only be switched on
and that switches off automatically. Merely touching the
touch key is sufficient to switch the appliance on, even
if it is not yet plugged into the mains. When you use the
coffee-maker for the first time, it is therefore possible
that it is already switched on (touch key is illuminated).
So prepare everything first (cleaning the appliance,
filling it with water and coffee) before placing the
appliance on the base station.
However if the coffee-maker has already heated up, it
must be allowed to cool down completely before you
use it. Otherwise the brewing process may be ended
prematurely or may not start at all.
BEEM – Elements of Lifestyle 19 / 52