Before Initial Use - Beem 08769 Mode D'emploi

21

Before Initial Use

PLEASE NOTE!
• Always set up the device with a clear space at the sides (at least 20 cm) and clear space
above it (at least 30 cm) on a fl at, solid and heat-resistant surface that is resistant to
splashing.
• Do not place the device below kitchen wall units or similar cupboards. The rising steam
could cause damage to them!
• The surfaces of furniture may possibly contain elements which can attack and soften the
feet of the device. If necessary, place a suitable pad below the feet.
• There may still be some production residues on the device. To avoid harmful effects
to your health, clean the device before you fi rst use it (see the "Cleaning and Care"
chapter).
1. Remove all packaging materials and any possible protective fi lms used for protection during
transportation. Never remove the rating plate and any possible warnings.
2. Wipe the device with a clean, damp cloth. Clean the permanent fi lter (4), the fi lter holder (1)
and the thermal cup (3) with mild detergent and warm water or in the dishwasher.
3. Place the device in a suitable location, following the safety notices and the notices provided at
the beginning of this chapter.
4. Fully unwind the connecting cable and insert the mains plug into a properly installed socket
that is easily accessible.
5. Before you enjoy your fi rst coffee, we recommend that you carry out a trial run to remove
any possible production residues in the water system. To do this, follow the instructions in the
"Preparation" chapter.
When the device is fi rst used, production-related additives (e.g. grease) may cause a small
amount of smoke and / or an odour to be produced. This is normal and not a device defect.
6. Perform this process twice. Do not drink this coffee!
7. Clean the device and accessories (see the "Cleaning and Care" chapter).
08769_DE-EN-FR-ES-IT_A5_V3.indb 21 08769_DE-EN-FR-ES-IT_A5_V3.indb 21
EN
13.01.2020 13:57:17 13.01.2020 13:57:17