Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3.6.2. Placing the logs and ashes
The complete set of imitation logs consists
of 6 logs and a small bag of ashes.
The logs must be positioned on the burner
as shown in the figure below. The position-
ing of the logs will be obvious because of
the positioning pins on the burner and on
the logs.
1. First, place log no. 1 at the back on the
supporting plate above the burner so
that it fits correctly on the positioning
pins.
2. Then place logs 2 and 3 to the left and
right on the burner.
3. Place log 4 at the front, to the right on
the burner and to the left on log 2.
4. Spread the ashes over the whole surface
of the burner. Take care that the ashes
are evenly distributed, covering the
complete surface.
5. Place logs 5 and 6 as shown in the fig-
ure above. Take care that they are fit-
ted correctly to the positioning pins on
log 1.
Note. The way in which the ashes are
spread over the burner surface helps
determine the appearance of the flames.
In certain cases it may be necessary to
adjust the distribution of the ashes
slightly by, e.g., partially uncovering a
few of the burner openings in order to
obtain a more even flame appearance.
3.7.
Finishing
Mount the glass door and secure it with the clips at the top and at the bottom. The
two small magnets on the glass pane must be at the bottom.
Hook the decorative frame over the raised ridge at the top of the glass door and
connect it with the 2 magnets at the bottom.
Light the unit and check to see that it is working satisfactorily.
2000DV - 2080DV
1
2
5
51
3
4
6
03.27987.000
Publicité
Table des Matières
