Instructions And Safety Instructions; General Safety Information - Wilo Drain TP 80 Notice De Montage Et De Mise En Service

English
• Incorrect repairs
• Inadequate construction site or construction work
• Chemical, electrochemical and electrical influences
• Wear
This means the manufacturer's liability excludes all lia-
bility for personal injury, material damage or financial
losses.
2 Safety
This section lists all the generally applicable safety
instructions and technical information. In addition, all
the other sections contain specific safety instructions
and technical information. All instructions and informa-
tion must be observed and followed during the various
phases of the pump's life cycle (installation, operation,
maintenance, transport etc.)! The operator is responsi-
ble for ensuring that all personnel follow these instruc-
tions and guidelines.

2.1 Instructions and safety instructions

This manual uses instructions and safety instructions
for preventing injury and damage to property. To clearly
identify them for personnel, the instructions and safety
instructions are distinguished as follows:
• Instructions appear in "bold" and refer directly to the
preceding text or section.
• Safety instructions are slightly "indented and bold" and
always start with a signal word.
• Danger
Serious or fatal injuries can occur!
• Warning
Serious injuries can occur!
• Caution
Injuries can occur!
• Caution (instruction without symbol)
Substantial property damage can occur. Irreparable
damage is possible!
•
Example:
Danger symbol: General hazard
Danger symbol, for example, electrical current
Symbol for prohibited action, e.g. No entry!
Instruction symbol, for example, wear protective
clothing
24

2.2 General safety information

• When installing or removing the device, never work
alone in rooms and sump. A second person must always
be present.
• The device must always be switched off before any
work is performed on it (assembly, dismantling, main-
tenance, installation). The device must be discon-
nected from the electrical system and secured against
being switched on again. All rotating parts must have
come to a standstill.
• The operator must report any faults or irregularities
that occur to a line manager immediately.
• The end-user must shut down the equipment immedi-
ately if defects occur that represent a safety risk.
These include:
• Failure of the safety and/or monitoring devices
• Damage to important parts
• Damage to electrical equipment, cables and insula-
tions
• Tools and other objects should only be kept in their
designated places so that they can be found quickly.
• Sufficient aeration must be provided when working in
enclosed rooms.
• When welding and/or working with electronic devices,
make sure there is no risk of explosion.
• Only use lifting gear which is legally defined as such
and officially approved.
• The lifting gear must be kept safely and must be suita-
ble for the conditions of use (weather, hooking unit,
load, etc.).
• Mobile equipment for lifting loads should be used in
such a way that it is guaranteed to remain stable during
operation.
• When using mobile equipment for lifting non-guided
loads, take action to prevent tipping, shifting, sliding,
etc.
• Measures should be taken to ensure that no person is
ever directly beneath a suspended load. Furthermore, it
is also prohibited to move suspended loads over work-
places where people are present.
• If mobile equipment is used for lifting loads, a second
person should be present to coordinate the procedure
if required (for example, if the operator's field of vision
is blocked).
• The load to be lifted must be transported so that no-
one will be injured if there is a power failure. Further-
more, if such work is being carried out outdoors, it
must be cancelled if the weather conditions worsen.
These instructions must be strictly observed.
Non-observance can result in injury or substan-
tial property damage.
WILO SE 2017/06