Danger In The Event Of Non-Observance Of The Safety Instructions; Safety Consciousness On The Job; Safety Instructions For The Operator; Safety Instructions For Installation And Maintenance Work - Wilo DrainLift XL Notice De Montage Et De Mise En Service

English
22

2.3 Danger in the event of non-observance of the safety instructions

Non-observance of the safety instructions can result in risk of injury to persons and dam-
age to the environment and the product/unit. Non-observance of the safety instructions
results in the loss of any claims to damages.
In detail, non-observance can, for example, result in the following risks:
• Danger to persons from electrical, mechanical and bacteriological influences
• Pollution of the environment due to leakage of hazardous materials
• Damage to property
• Failure of important product/unit functions
• Failure of required maintenance and repair procedures

2.4 Safety consciousness on the job

The safety instructions included in these installation and operating instructions, the exist-
ing national regulations for accident prevention together with any internal working, oper-
ating and safety regulations of the operator are to be complied with.

2.5 Safety instructions for the operator

This appliance is not intended for use by persons (including children) with reduced physi-
cal, sensory or mental capabilities, or lack of experience and knowledge, unless they have
been given supervision or instruction concerning use of the appliance by a person respon-
sible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
• If hot or cold components on the product/the unit lead to hazards, local measures must be
taken to guard them against touching.
• Guards protecting against touching moving components (such as the coupling) must not
be removed whilst the product is in operation.
• Leakages (e.g. from the shaft seals) of hazardous fluids (which are explosive, toxic or hot)
must be led away so that no danger to persons or to the environment arises. National stat-
utory provisions are to be complied with.
• Danger from electrical current must be eliminated. Local directives or general directives
[e.g. IEC, VDE etc.] and local power supply companies must be adhered to.

2.6 Safety instructions for installation and maintenance work

The operator must ensure that all installation and maintenance work is carried out by
authorised and qualified personnel, who are sufficiently informed from their own detailed
study of the operating instructions.
Work on the product/unit must only be carried out when at a standstill. It is mandatory that
the procedure described in the installation and operating instructions for shutting down
the product/unit be complied with.
Immediately on conclusion of the work, all safety and protective devices must be put back
in position and/or recommissioned.

2.7 Unauthorised modification and manufacture of spare parts

Unauthorised modification and manufacture of spare parts will impair the safety of the
product/personnel and will make void the manufacturer's declarations regarding safety.
Modifications to the product are only permissible after consultation with the manufac-
turer. Original spare parts and accessories authorised by the manufacturer ensure safety.
The use of other parts can nullify the liability from the results of the usage.

2.8 Improper use

The operating safety of the supplied product is only guaranteed for conventional use in
accordance with Section 4 of the operating instructions.
The limit values must on no account fall under or exceed those specified in the catalogue/
data sheet.
WILO SE 03/2011