Integra MAYFIELD 2 A3100 Mode D'emploi page 12

EN – ENGLISH
Before fully tightening, always be certain that the starburst teeth of the Swivel Adaptor and other starburst fittings are the
same size and properly mesh. Failure to do so may damage fittings and/or allow unwanted movement of the patient. Figure
10 shows a typical starburst connection and proper meshing of teeth. (See Figures 10A and 10B)
Figure 10A Proper Meshing of Teeth
(If attaching a Horseshoe Headrest, bring the Transitional Arm to the proper height. The mounting screw of the large
starburst on the Swivel Adaptor should be inserted into the large starburst of either the Horseshoe Headrest or the
Conversion Adaptor if used. Turn mounting screw on the top of the Swivel Adaptor clockwise to tighten.)
11
Proper Meshing of Teeth
CAUTION!
Figure 10B Improper Meshing of Teeth
Improper Meshing of Teeth