Unpacking; Disposal Of The Packaging; Requirements On The Installation Location; Electrical Connection - Graef DA2042 Mode D'emploi

UNPACKING

When unpacking the unit, proceed as follows:
Pull the unit out of the cardboard box.
●
Remove the packaging parts.
●
Remove any stickers on the unit (do not remove the type plate).
●

DISPOSAL OF THE PACKAGING

The packaging protects the unit against transport damage. The packaging materi-
als are selected according to the environmental compatibility and disposal-related
aspects and can be recycled. The return of packaging into the material cycle saves
raw material and reduces the waste volume. Dispose of the packaging material
no longer needed at collection points for the "Green Dot" recycling system (in
Germany).
IMPORTANT!
If possible, keep the original packaging during the guarantee period of the unit
in order to be able to properly pack and transport the unit in the guarantee case.

REQUIREMENTS ON THE INSTALLATION LOCATION

For safe and fault free operation of the unit, the following requirements of the
installation location have to be met:
The unit has to be placed on a solid, flat, horizontal, and non-slipping surface
●
with a sufficient weight-carrying capacity.
Make sure that the unit cannot topple over and does not stand directly in front
●
of a wall (place the unit at least 30 cm away from a wall).
Do not place the appliance on hot surfaces, such as hotplates, or near them.
●
Never use the appliance outdoors, and always keep it in a dry place.
●
The unit is not designed for installation in a wall or a built-in cupboard.
●
Do not set up the unit in a hot, wet or moist environment.
●
Do not place the unit on paper / newsprint paper or loose surfaces. They might
●
be drawn in and clog the ventilation slots. Make sure that the ventilation slots
are not covered up.
The socket has to be easily accessible so that the power cable can be removed
●
easily in case of emergency.

ELECTRICAL CONNECTION

For safe and fault-free operation of the unit, the following requirements have to
be met during the electrical connection:
Before connecting the unit, compare the connecting data (voltage and fre-
●
quency)
on the type plate with those of your energy network. These details must
24