Operating Instructions - TensCare Unicare Mode D'emploi

13.2. OPERATING
INSTRUCTIONS
ON/OFF
To turn the unit on, press the
ON button and hold for 3 to
5 seconds until the display
shows. To turn the unit off, press ▼
button to remove keypad lock and
press the OFF button and hold for 3
to 5 seconds until the display stops.
At first use, or after changing
batteries, the display shows that the
unit is automatically
programme STRES at zero strength.
When switched on the unit will
automatically
programme which was being used
when it was last switched off.
The unit will turn off automatically:
• When the Timer reaches zero,
• If it is left at zero strength for more
than 5 minutes.
Note: Always check unit is
OFF before
removing probe or pads.
The backlight will turn off 10 seconds
after the last button press.
STRENGTH CONTROLS
The buttons marked ▲ and
▼ are the strength controls.
To increase strength, press
and hold down the button
set in
start in the
applying or
▲ until required
achieved.
To decrease the strength, press and
release the button ▼.
To increase strength in steps of 1 mA,
press and release the button ▲.
The unit will remain in the WORK part
of the cycle for 5 seconds while
intensity is being adjusted.
The strength levels are shown on the
LCD display.
The strength control buttons will not
operate until the unit is properly
connected to you (probe inserted
correctly). Unicare
disconnection and automatically
returns the strength to zero.
The unit has 99 levels of strength. If
you hold down the button ▲ for 3 to
5 seconds, the strength will start
scrolling.
You may feel nothing over the first
few presses. Continue pressing until
the sensation
comfortable. Further
during use may be necessary if your
body becomes
sensation.
The yellow LED on the output socket
indicates that there is an active
output. The display will remain on for
5 seconds after the plug is removed.
24
strength is
detects a
is strong but
increases
used to the